| Rifle Work |
|---|
| Complete cleaning of rifle, oil and test fired |
| Lever, pump and auto |
| Check headspace (no charge if done with other work) |
| Forge bolt handle for low scope (no polishing) |
| Polish complete bolt |
| Inlet receiver and stock for bolt handle |
| New bolt handle installed |
| Adjust trigger pull (where possible) |
| Hone sear surfaces on military trigger for crisp let off |
| Cut barrel to any length and crown same |
| Engine turn bolt and polish |
| Open bolt face and extractor for magnum cartridge |
| Above for series 700, 721, & 722 Rem.(incl. install new Sako type extractor) |
| Headspace adjusted, barrel set back & properly rechambered |
| Open rails & feed chute, if necessary, on above |
| Bush firing pin holes & alter firing pin to fit on rolling blocks, Winchester hi-walls, etc |
| Win. 92 converted .218 Bee, 357 Mag., 44 Mag.(with new barrel and blue) |
| Barrels straightened (rifle or shotgun)no double barrels, no ribs |
| Muzzle brake installed |
| Stainless steel muzzle brake installed |
Enfield 1917 |
| Mill off Ears, Grind Receiver to Model 70 or 30 Contour |
| Straighten Trigger Guard |
| Reduce depth of magazine |
| Grind rifle chute to feed round nose bullets |
| Speed lock Enfield<*> and 93 & 95 Mausers |
